Burning
a Chip
Page2
This is the actual PROGRAMMING or DOWNLOADING A PROGRAM
section. This is what you have been waiting for. This is where you actually
put a program into the PIC chip and see what happens.
The things you need are:
- the 5x7
Display
Project (fully built)
with 6v battery.
See construction HERE.
- an interface cable (the
components come with the Multi-Chip Programmer).
- IC-Prog.exe Click HERE.
(See below first)
- a computer.
PROGRAMMING/BURNING
STARTS HERE
Build the 5x7
Display Project, insert the PIC chip and switch ON. The TEST ROUTINE in the
chip will display features on the screen to test each of the LEDs and also the
correct wiring of the components. Go to: Test
Routine to see the test routine program.
If the Test Routine produces the correct display on the screen you are ready for the
next step.
To load the experiments into the PIC chip you need a program called: IC-Prog.
All the .hex files for the project are in 5x7hexFiles.zip. See
above for downloading. Put the 5x7hexFiles.zip file in IC-Prog folder. This will put the .hex files and
IC-Prog program in the same folder and make it easy to load each .hex file
into IC-Prog. Unzip the 5x7hexFiles.zip file in the folder. This will
produce more than 35 .hex files.
. Make sure the
5x7 Display project is switched ON. Make sure the interface cable is
connected. Slide the run/pgm switch to pgm.
"Burn" the chip by using IC-Prog.
Slide the run/pgm
switch to run and the screen will show the results of the program.
|